What are the DIP switch positions to allow auto ranging?

All APMs are shipped from the factory in auto-ranging mode. 

If you have changed the configuration and want to return back to auto-ranging: 

  1. Make sure that all the DIP switches on the rear of the unit are pointing to the left (away from the screw terminals) as shown below. 
  2. Run the APM configuration software and select ‘Auto Ranging’ before writing the configuration to the APM.

apm configuration software screenshot

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us