APM-IOT-GATEWAY PINOUTS AND STATUS

Hardware Configuration

                Device wiring

1.       Connect APM(s) to the APM Gateway as per wiring diagram

APM-IOT-GATEWAY WIRING INCLUDING RELAY - Trumeter Knowledge Base

2.       Plug in Ethernet cable to the RJ45 ethernet port

3.       Configure meters to ensure alarms are set (APM configurator)

4.       Check all wiring connections are correct

             Powering Device

1.       Power the APM Gateway using an external 12-24VDC/VAC source

2.      LED Status

   RED – Not Connected to Cloud

GREEN – Connected to Cloud

3.      Confirm each APM connection Link LEDs are active depending on how many meters are connected to the APM Gateway

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us